91
edits
Changes
Jump to navigation
Jump to search
no edit summary
Line 19:
Line 19:
Test+
+
+
+
* [ https://www.millerwelds.com/files/owners-manuals/o1325a_mil.pdf ]
* [ https://www.millerwelds.com/files/owners-manuals/o1325a_mil.pdf ]
−= Test =
+= Procedures: =
−'''Procedures:'''
+Prior to Welding
+# Place the fume hood over the area you will be welding at
+# Attach the ground clamp to the bench your workpiece will be on
+# Ensure the workpiece is touching the conductive surface of the table
+# Ensure the adjusting screw on the tank regulator is loose (Do not unscrew all the way)
+# Open cylinder valve all the way
+# Turn the adjusting screw (clockwise) to increase pressure to 15 CFH.
+# Identify material type and thickness that is going to be welded
+# Refer to MIG welding chart for specified adjustments, specific to your application
+# Turn on the welder and adjust wire speed and voltage
+# Ensure you are wearing all necessary protective gear
+# Ensure the welding torch has proper amount of wire protruding from tip (about ¼ inch) If too long, trim excess with the welding pliers.
+# Weld!
+After Welding
+# Close gas cylinder valve
+# Bleed remaining gas by depressing trigger until regulator drops to 0
+# Back out adjusting screw on regulator (Do Not unscrew all the way)
+# Turn off the welder
+# Remove ground clamp