1,947
edits
Changes
Jump to navigation
Jump to search
Line 50:
Line 50: − You will need to demonstrate your ability to setup the table saw and safely perform a rip cut and a cross cut. You will be given a piece of lumber and asked to setup the saw to make a rip cut. After successful completion of the rip cut you will be asked to make a cross cut.+
→Operation
====Operation====
====Operation====
The SawStop table saw has a unique safety feature. A spring loaded cartridge is located in the machine. Any conductive material that makes contact with the blade fires and jams the cartridge block into the blade. The blade then stops spinning and drops down out of the way into the body of the saw. All this happens within 5 milliseconds, helping to ensure the blade inflicts minimal damage. If the material you are cutting is wet or has gold paint or leaf it will most likely trigger the saw stop feature. Do not cut any wet lumber or metal coated materials with this machine. Charcoal is also conductive so any laser cut areas of lumber should not make contact with the blade while cutting.
====Demonstration====
====Demonstration====