Difference between revisions of "Spot Welder"
Jump to navigation
Jump to search
| (2 intermediate revisions by one other user not shown) | |||
| Line 5: | Line 5: | ||
|Is used in domain= | |Is used in domain= | ||
|Has name={{PAGENAME}} | |Has name={{PAGENAME}} | ||
| + | |Has make=Miller | ||
| + | |Has model=LMSW-52 | ||
| + | |Has serial number=MJ328801N | ||
| + | |Has life expectancy= | ||
| + | |Has year of manufacture or purchase= | ||
| + | |Has replacement cost= | ||
|Has icon=File: Spot_welderIcon.png | |Has icon=File: Spot_welderIcon.png | ||
|Has icondesc=Reflow Oven Icon | |Has icondesc=Reflow Oven Icon | ||
| Line 11: | Line 17: | ||
|Has description= | |Has description= | ||
|Has certification=https://georgefox.instructure.com/courses/1281 | |Has certification=https://georgefox.instructure.com/courses/1281 | ||
| − | |||
| − | |||
| − | |||
|Has group=Circuit Board Design | |Has group=Circuit Board Design | ||
|Has ace=Levi Gibson;lgibson19@georgefox.edu | |Has ace=Levi Gibson;lgibson19@georgefox.edu | ||
Revision as of 12:58, 23 January 2023
Make: Miller
Model: LMSW-52
Serial Number: MJ328801N
Ace: Levi Gibson (lgibson19@georgefox.edu).
Location: Welding Shop
Safety First
- Wear gloves and welding helmet.
- Don't have bare skin exposed.
- Don't weld in wet gear or standing water.
- Welded material will be hot.
Description
Resistance spot welding is a process in which contacting metal surface points are joined by the heat obtained from resistance to electric current. The Miller LMSW-52 Air-Cooled Spot Welder is a lightweight unit that is portable, easy to operate and excellent for welding mild, galvanized or stainless sheet materials.
- LMSW-52 spot welder manual [1]
Here is an example of spot welding and some good basic information.
Documentation
Terminology
- Tongs-
Training
Operation
Here are some general setup rules of thumb:
- The maximum weld capacity is 2 sheets of 16 gauge material.
Demonstration
For the demonstration you will need to perform a spot weld using two pieces of scrap material.
General Procedure
- Ensure the material being welded should be clear of any oil or dust
- Turn on the spot welder
- Place the material being welded between the clamps.
- Clamp down on the two pieces of material for approximately 2 seconds. The time required to weld may vary slightly depending on the material and thickness.
- Grab workpiece with a set of pliers, and open the clamp.
Certification
Troubleshooting
Maintenance
General maintenance
The welding tips should be inspected and cleaned as needed.
Specific Maintenance Tasks
| Maintenance Procedure | Frequency | Done By |
|---|---|---|
| xxx | xxx | Student/Tech |
| xxxx | xxxx | Student/Tech |
| xxxx | xxxx | Student/Tech |