Revision as of 11:45, 13 March 2019

Miller Spectrum® 875 Plasma Cutter with 20 foot XT60 torch has compact size but 60 amps of output power.

It features easy operator controls, for optimum cutting and gouging performance.

The current Ace of the Plasma Cutter is Levi Gibson (lgibson19@georgefox.edu).

Documentation:

Place fume hood over the area you will be welding at
Turn air on
Turn plasma cutter on
Attach ground clamp
Measure thickness of material being cut and refer to chart for current setting on machine
Set the current on the plasma cutter
Place the drag shield on the edge of the base metal, or hold ⅛ inch off the surface. Direct the arc straight down.
Raise the trigger lock and press the trigger, this will engage the pilot arc
Once the cutting starts, begin to slowly move the torch across the metal
Adjust your speed so the sparks go thru the metal and out the bottom of the cut
At the end of the cut, angle the torch slightly towards the final edge or pause briefly before releasing the trigger
Turn off machine
Turn off air
Disconnect ground clamp

@@ Line 16: / Line 16: @@
 }}
 [[{{#show: {{FULLPAGENAME}}|?Has icon|link=none}}|100px|left|top|{{#show: {{FULLPAGENAME}}|?Has icondesc}}]]
-[[{{#show: {{FULLPAGENAME}}|?Has image|link=none}}|thumb|upright=1.5|{{#show: {{FULLPAGENAME}}|?Has imagedesc}}]]
+[[{{#show: {{FULLPAGENAME}}|?Has image|link=none}}|300px|thumb|upright=1.5|{{#show: {{FULLPAGENAME}}|?Has imagedesc}}]]
 Miller Spectrum® 875 Plasma Cutter with 20 foot XT60 torch has compact size but 60 amps of output power.