2,292
edits
Changes
Jump to navigation
Jump to search
Line 84:
Line 84: − + Line 116:
Line 116: − + Line 122:
Line 122: − +
no edit summary
<br>
<br>
<br>
<br>
<strong>Step 16:</strong> You should now have a 3D egg similar to the screenshot below. However, this design is not ready for 3D printing. You can click and hold the scroll wheel to rotate the egg, and you'll notice that the 6mm line at the bottom of the egg has now turned into a 12mm diameter circle. We have intentionally made this flat spot a little larger to get better adhesion to the base plate during the print, but it is not sufficient on its own to keep the egg from tipping over in the event that the nozzle crashes into it. Later on, we will add supports to the bottom part of the egg using the Prusa 3D Slicer software that will support the shallow parts of the egg's curvature. But for now, we are going to add structural supports in SolidWorks that will mitigate the risk of the egg tipping over in the middle of the print.
<strong>Step 16:</strong> You should now have a 3D egg similar to the screenshot below. However, this design is not ready for 3D printing. You can click and hold the scroll wheel to rotate the egg, and you'll notice that the 6mm line at the bottom of the egg has now turned into a 12mm diameter circle. We have intentionally made this flat spot a little larger to get better adhesion to the base plate during the print, but it is not sufficient on its own to keep the egg from tipping over in the event that the nozzle crashes into it. Later on, we will add supports to the bottom part of the egg using the PrusaSlicer software that will support the shallow parts of the egg's curvature. But for now, we are going to add structural supports in SolidWorks that will mitigate the risk of the egg tipping over in the middle of the print.
[[File:Egg 16.1.png|1500px|none]]
[[File:Egg 16.1.png|1500px|none]]
<br>
<br>
<br>
<br>
<strong>Step 22:</strong> You should now have something that looks like an egg spaceship. Save your work! Then press Save As to save your file as a STL (*.stl). You will bring your STL file into the prototype lab to set it up on the Prusa 3D Slicer.
<strong>Step 22:</strong> You should now have something that looks like an egg spaceship. Save your work! Then press Save As to save your file as a STL (*.stl). You will bring your STL file into the prototype lab to set it up in PrusaSlicer.
[[File:Egg 22.png|1500px|none]]
[[File:Egg 22.png|1500px|none]]
<br>
<br>
==Prusa 3D Slicer==
==PrusaSlicer==
<strong>Step 23:</strong>
<strong>Step 23:</strong>