Changes

[[File:HP Step 6.jpg|none|thumb]]

[[File:HP Step 6.jpg|none|thumb]]

2. Check the distance between the end of the pin to be pressed and the ram.  If the gap is too large the ram will run out of travel before pressing out the pin.  

2. Check the distance between the pin extraction tool and the ram.  If the gap is too large the ram will run out of travel before pressing out the pin.  

[[File:HP Step 8.jpg|none|thumb]]  

[[File:HP Step 8.jpg|none|thumb]]  

3. If you need to adjust the table frame height remove the safety clips from the pins supporting the table and remove the table plates and assembly pieces. Remove everything from the table to prevent accidentally dropping items on your feet.  

3. If you need to adjust the table frame height remove the safety clips from the frame pins supporting the table and remove the table plates and assembly pieces. Remove everything from the table to prevent accidentally dropping items on your feet.  

4. To move the table frame down you will remove the two upper pins and reinstall them in the correct holes below.

4. To move the table frame down you will remove the two upper pins and reinstall them in the correct holes below.