1,956
edits
Changes
Jump to navigation
Jump to search
Line 104:
Line 104: − + − +
→General Procedure
1. Place the plate with the installed pin on top of the table support plates. You will need to leave a gap between the plates for the pin to press though.
1. Place the plate with the installed pin on top of the table support plates. You will need to leave a gap between the plates for the pin to press though.
2. Check the distance between the end of the pin to be pressed and the ram.
2. Check the distance between the end of the pin to be pressed and the ram. If the gap is too large the ram will run out of travel before pressing out the pin.
3. If you need to adjust the table frame height remove the safety clips from the pins supporting the table and remove the table plates and assembly pieces. The table plates are heavy so don't drop them.
3. If you need to adjust the table frame height remove the safety clips from the pins supporting the table and remove the table plates and assembly pieces. Remove everything from the table to prevent accidentally dropping items on your feet.
4. To move the table frame down you will remove the two upper pins and reinstall them in the correct holes below.
4. To move the table frame down you will remove the two upper pins and reinstall them in the correct holes below.