473
edits
Changes
Jump to navigation
Jump to search
Line 101:
Line 101: − + + + − Insert text+
no edit summary
==Troubleshooting==
==Troubleshooting==
* The job runs but machine does not cut. Most likely the dry run process selected. Toggle dry run off.
* The job runs but machine does not cut. Most likely the dry run process selected. Toggle dry run off.
*
* The machine does not cut, many sparks visible. The process table is not set correctly or the cutting head or optics is dirty. Ensure correct focal offset, cut speed, cut height, and gas pressure in process table. Check that the nozzle tip is clean, wipe off slag with Scotchbrite.
* Machine loses cut so that there crooked lines and gaps in the part. Again this is because the process table parameters incorrect or the cutting head/optics are dirty. Verify cut process parameters including cut speed, cut height, and gas pressure. Check nozzle tip is clean, wipe off slag with Scotchbrite.
* Cut does not go all the way through material
==Maintenance==
==Maintenance==
====General maintenance====
====General maintenance====
Just like any other machine tool, the FabLight must be cleaned regularly for optimal performance. Lack of regular preventative maintenance (PM) will lead to damaged machine components, a reduction in part quality, and machine downtime. Cleaning the entire machine takes on average 10 minutes to complete and is easy to do with a single person. Even if the machine does not appear to be dirty, over time metal particles can build up; for optimum machine performance you must adhere to the recommended PM schedule, even if the machine “does not appear to be dirty.”
====Specific Maintenance Tasks====
====Specific Maintenance Tasks====