142
edits
Changes
Jump to navigation
Jump to search
Line 32:
Line 32: − + + + +
no edit summary
** The Form 2 utilizes the Upside Down or Inverted orientation.
** The Form 2 utilizes the Upside Down or Inverted orientation.
*** The resin tank has a clear bottom with a surface the resin will not stick to. This allows the resin to cure against the bottom of the tank.
*** The resin tank has a clear bottom with a surface the resin will not stick to. This allows the resin to cure against the bottom of the tank.
*** The build platform is lowered into the tank.
*** The build platform is lowered into the resin until it is hovering above the bottom surface of the tank, as far away as the height of the layer to be constructed.
*** The laser is directed through the bottom of the tank and cures a layer of resin onto the build platform. Then, the resin tank slides over and the build platform raises. The wiper will then sweep across the tank to circulate the resin.
*** The build platform will lower again, and the process will be repeated until the print is completed.
*** Due to friction caused by de-laminating every layer, every part should be canted in its orientation. This means the part should be angled to reduce the cross sectional area needing to be shifted to de-laminate each layer.